Basement Waterproofing in New Richmond, WI
Water that gets into a basement leaves a trail. You’ll see damp patches and tide marks along the base of the walls, white chalky deposits on the block, or rust stains near the floor drain and sump. In a finished basement, it shows up as peeling paint, bubbling drywall, wet carpet, and the musty smell of mold growing behind the walls.
Standard Water’s basement waterproofing stops that water at the bottom of the wall. Crews cut back the floor along the perimeter, open the bottom of each block core so trapped water can drain, and lay rigid PVC drain pipe beside the footing, sloped to a sump pump that sends the water outside. The rigid pipe holds up to New Richmond’s iron-bearing groundwater, because its larger holes don’t clog with mineral buildup the way flexible pipe can. A moisture barrier goes down before the new concrete is poured, and the system carries a transferable limited lifetime warranty.
Foundation Repair in New Richmond, WI
A foundation that’s moving can show it anywhere in the house. In the basement, you might find cracks in the walls, a wall bulging inward, or water weeping through a crack after a heavy rain. Upstairs, the signs are doors that stick or won’t latch, floors that slope, cracks running from the corners of doorways and windows, and gaps opening between the walls and the ceiling. Outside, look for cracked brick or a chimney pulling away from the house.
Standard Water’s foundation repair starts with a free inspection to find out what is actually moving. A wall pushed inward by the soil, a crack letting water through, and a section of the house that has settled are different problems, and a single home can have more than one. The inspection sorts out which repairs your home needs before any work is scheduled.
Carbon Fiber Straps for Bowing and Cracked Walls
Carbon fiber straps reinforce a basement wall that is bowing or cracking under pressure from the soil outside. Each strap is bonded flat to the wall with epoxy, locking the wall in place so it can’t move any farther inward. The straps sit flush against the wall and won’t rust or rot, and once the epoxy cures, the wall can be painted.
Crack Injection for Leaking Poured Walls
Cracks in a poured concrete wall are sealed by injection from the inside. The crew sets ports along the crack and fills it under pressure, using polyurethane when the goal is stopping water and structural epoxy when the crack needs to bond back to full strength. Either way, the crack is sealed against leaks and held closed.
Helical Piers for Settling Foundations
When the soil under a footing gives way and part of the house drops, helical piers take over the load. Each pier is driven down through the clay to firmer ground or bedrock, then connected to the footing. With the weight of the house resting on the piers, the settling stops, and the repair is backed by a transferable limited lifetime warranty like the rest of Standard Water’s foundation work.
Radon Mitigation in New Richmond, WI
Radon is a radioactive gas that forms as uranium breaks down in soil and rock. It gets into a house through cracks in the slab, the joint along the floor, an open sump pit, or a bare crawl space floor. Because it has no color or smell, a test is the only way to learn your home’s level. St. Croix County Public Health sells short-term test kits at the County Services Center on Dorset Lane in New Richmond, and Standard Water provides free test kits to homeowners in western Wisconsin.
If your result comes back at 4.0 pCi/L or higher, the EPA recommends installing a mitigation system. Standard Water’s NRPP-certified crews install sub-slab depressurization systems. The crew first seals the cracks and openings where soil gas gets in. Then it cuts a suction point through the basement floor and connects it to a pipe and a continuously running fan that vents the gas above the roofline. Homes with crawl spaces get a sealed membrane over the dirt floor, with the suction drawn from underneath it.
Most installations take a single day, and Standard Water pulls any permits the job needs. You retest within 30 days. If the level isn’t below 4.0 pCi/L, the crew comes back and adjusts the system at no cost until it is.
Crawl Space Encapsulation in New Richmond, WI
A crawl space with a bare dirt floor stays damp, and that moisture reaches everything around it. Wood framing can soften and rot, insulation sags, and mice and insects move in. The musty smell from below travels up into the rooms over it.
Standard Water’s crawl space encapsulation seals the space off from the ground beneath it. A ventilation system draws moisture, odors, and soil gases out from under the crawl space and vents them outside the house. The crew then covers the floor and walls with a heavy-duty vapor barrier and seals every seam with adhesive. The barrier resists tears and punctures and meets fire code, and it turns a dark, dirty crawl space into a clean, bright area you can use for storage.
Mold Remediation in New Richmond, WI
Mold takes hold wherever moisture lingers, and in a home with a damp basement or crawl space, that can mean drywall paper, wood framing, carpet, and stored boxes. You might see black, green, or white patches on a wall, or notice a musty smell that comes back however often you clean. Once it’s established, mold spreads across the material it’s growing on and breaks it down.
Mold remediation from Standard Water starts with an inspection and testing to find every area the mold has reached. The crew seals off those areas so spores don’t spread through the house during the work, removes the mold with specialized equipment and EPA-approved products, and cleans and restores the surfaces. Air quality testing after the work confirms the space is clear, and you get documentation of the results.
The inspection also tracks down where the moisture is coming from. Depending on what it finds, the fix could be waterproofing the basement, sealing a leaking crack, or adding a dehumidifier. Dealing with the moisture at the same time keeps the mold from growing back in the same spot.
Egress Windows and Sump Pumps in New Richmond, WI
An egress window gives a finished basement a code-compliant emergency exit and brings daylight into the space. Standard Water pulls the permit and has utilities located before any digging starts, then excavates by hand with plywood laid over the lawn to protect it. The crew cuts the opening with a diamond-blade saw, trims and seals the window, and anchors a window well to the wall with gravel backfill for drainage. If the home already has a Standard Water drain tile system, the well drains into it.
For a sump that’s failing or was never set up right, Standard Water installs a new sump pump system. The basin gets a bolted, airtight cover, a submersible pump, and a high water alarm, along with a second discharge line ready for a battery backup. Water leaves the house through a single continuous buried pipe with no joints, so the line won’t freeze up in a Wisconsin winter.